Appendix 6: Analysis of solutions observed in the field. Use of one ascender and clipping into knots on a second rope

This solution is described here because it is often seen in use. It has poor ergonomics and a high risk of error.

PRIMARY SYSTEM: ONE ASCENDER ON THE PRIMARY ROPE.

SECONDARY SYSTEM: PRE-TIED KNOTS SPACED REGULARLY ON THE SECOND ROPE FOR CLIPPING WITH A LANYArd.

ADVANTAGES:

- Simplicity of the system and its installation

- Low equipment cost

Disadvantages:

- The second rope cannot be considered a belay system unless the climber is continuously connected to it A Y-lanyard must be used and the user must be clipped to the next knot before unclipping from the last knot.

- Average ease of use: the climber lifts the secondary rope with each move upwards, and supports its weight

- In case topping out is necessary to exit the route, retrieving a rope with many knots in it could be complicated or even dangerous

Risks in case of primary ascender malfunction:

- Significant potential fall length

- With an I-lanyard, the secondary belay system is not continuous

?Close to the belay station, there is a risk of a fall factor 1: beware if the rope is semi-static.

With a static lanyard, the fall factor close to the belay station can be greater than 1. (A dynamic rope lanyard is preferred.)

【轉(zhuǎn)自：https://www.petzl.com/US/en/Sport/Appendix-6--Analysis-of-solutions-observed-in-the-field--Use-of-one-ascender-and-clipping-into-knots-on-a-second-rope?ActivityName=Rock-climbing】