傳統溫度傳感器電池取電or感應取電。

電池取電的弊端在于電量耗盡后，更換會有更換期間數據中斷。感應取電需要啟動值，未到達啟動值時無法工作。

新穎的設計理念

1 安裝指南

1 Installation Guide

1.1 產品概述

1.1 Product Introduction ACE100 無線溫度電流復合傳感器主要用于低壓開關柜輸電電纜的的溫度和電流的檢測。傳感 器采用內部電池和電磁取能的雙供電方式，快速準確的測量低壓電纜的溫度及電流數據，通過無線 的方式上傳至接收裝置。產品安裝方便，全面檢測電纜數據，可幫助用戶及早發現線路隱患，保障 供電安全，實現配電網絡智能化。 The ACE100 wireless temperature & current sensor is mainly used to detect the temperature and current of the transmission cable of the low-voltage switchgear. The sensor adopts the dual power supply mode of internal battery and electromagnetic energy extraction to quickly and accurately measure the temperature and current data of low-voltage cables, and upload them to the receiving device via wireless. The product is easy to install and comprehensively detect cable data, which can help users find hidden dangers in the line as early as possible, ensure power supply safety and realize intelligent distribution network.

型號說明

技術指標

技術指標

1.4 產品安裝

1.4 Product Installation

1.4 產品安裝

1.4 Product Installation

ACE100 無線溫度電流復合傳感器，采用開口型卡扣式安裝方式。安裝時將傳感器貼緊待測電

纜，完全扣緊 CT 卡扣。當電纜電流小于傳感器感應取電啟動電流時，傳感器使用內部電池進行工

作，如果電流大于傳感器感應取電啟動電流，傳感器將感應取電工作，節省電池電量。

The ACE100 wireless temperature & current sensor is installed in an open snap type. During

installation, the sensor shall be tightly attached to the cable to be tested, and the CT snap shall be fully

1.5 使用方案

1.5 Usage scheme

觸摸屏 ATP007/ATP010 搭配 ATC600-C： HMI ATP007/ATP010 with ATC600-C: